PARTICAL PROBLEM IN VLSI AND WITH SOLUTION WITH COMMANDS IN INNOVUS

This Blog is give the introduction of the problem in the implementation of the design in cadence innovus and solve then using commands and give explanation using the our solution:

Challenges in the floorplan:

1) How do we decide the core area and die are :

the core and die are a are decided based on the area of the core :

the die height should be multiple of  row height (D.H) = R.H *n

width of die area is sqrt of the area of the block.


#DIE  WIDTH                  [expr sqrt($core_area) ]

#set coreW                               [expr int($WH/polypitch*8)*polypitch*8]

#set coreH                               [expr int($WH/R.H*2)*R.H*2]

#set boundary_offset_x   [expr  polypitch*3 ]

#set boundary_offset_y   1.3520


The polypitch is distance between the poly to poly

Pin placement :

 the pin placement is based on the top level place of ports. Even i we pin assignment issues we should follow the same placement.

Macro placement :

 the macro placed at the cordinates of the llx should be multiple of polypitch

the macro lly sould be multiple of the row height.

Adding of the Well taps and endcaps :

the end cap are placed at the end of the core area and the single row height cells are placed at the core row, and double height well taps are placed are core edge. The endcaps should also place around the macros also.

power planning :

the power planning should in the ration of 80 % and remaining for the 20% for the data signal routing.




Comments

Popular posts from this blog

OCV AND TYPES OF OCV ANALYSIS , AOCV,POCV,SOCV

MY LIFE STORY